Mixer Control Room Vs Main Out

Main mix outputs and aux output s are mixes that are sent to yo.

Mixer control room vs main out.

Both are fed on channel 7. The main out i use to feed into soundcard. Mixer mbox mini 2 control room and main out questions if this is your first visit be sure to check out the faq by clicking the link above. It is normally used for setting the gain on channels.

I take sound card out and feed that to the desk tape in which i route to the control room. Ok here goes the newbie guide to solo modes. Use that to monitor the main out when you need to. By doing it this way any changes to listening level are independent of desk settings.

Ok octevio the main outs on a mixer console is your stereo output sockets the connectors are a 3 pin xlr on your larger console but it can also be a 6 5 mm trc jack sockets or rca. Control room speakers are to be hooked up to the large and small 1 4 trs connectors. I connect monitors and headphones via control room out not main out. Stereo out balanced xlr connections 1 ground 2 hot 3 cold which output the stereo buss signals which can be used to feed the analog inputs of a 2 track recorder or a specialist chain of analog devices used for mastering.

If you are in the room with the mixer then that is the control room. There is also a min mix switch that send the main mix output to the phones cntrl room output. Just give it a go. There are 3 major solo modes you can encounter on a mixer.

Pfl afl and sip pfl pre fader listening will route the selected signal to the monitors before fader pan and eq so you can hear the signal as it is when it comes into your mixer. 1 2 original message date. Then i tweaked the control room out volume knob on the behringer until it had the same overall gain as the soundcraft. All buttons were depressed except for the main to control room button on the behringer.

Click the register link above to proceed. The behringer is recorded on the left control room output the soundcraft on aux 2.