Missed Spot Polyurethane Floor

How can i fix this without compounding the problem.

Missed spot polyurethane floor.

I put a final coat of polyurethane on my wood floors and noticed that i missed a spot where my roller didn t overlap in application after the floor completely dried i tried touching it up by rolling on some poly but the finish is matte and somewhat cloudy from what i first applied. Missed spots in polyurethane on hardwood floor. I put a final coat of polyurethane on my wood floors and noticed that i missed a spot where my roller didn t overlap in application after the floor completely dried. But even the most careful.

There s a sheen difference on the missed spots but the color is consistent. I assume that you have a polyurethane floor so i will base my answer on that. Applying polyurethane in even coats is a crucial though not always simple task. I am using minwax super fast drying clear satin.

Can i just add some polyurethane coating to the missed spots or is that going to cause an issue. With a little tender loving care they can keep their soft shine for years. The dull and shiny spots in your hardwood floor indicate that your installers did not apply the finish correctly. When it comes to finishing furniture or hardwood floors polyurethane is the key to protecting and preserving the stain.

The process is straightforward. I m wondering how long this coat will really last given it wasn t sanded first. Use solvent based polyurethane and get the same finish type gloss satin etc and apply a few thick coats. Focus on that one small area and ignore the rest of the floor.

Dull spots in polyurethane floors usually indicate that the finish was not applied carefully the applicator had a dry spot on it or the finish was thinned out with a solvent such as mineral spirits. Using a good quality polyurethane and a china bristle brush and three differ. While applying the last coat of poly to a traditional 3 4 red oak strip floor in poor light i didn t overlap the edge for about about 10 12 and the width of one of the boards. The part i missed is pretty evident in the correct light.

Typically two to three coats are used with sanding in between coats to even them out. Once the finish is dry you can do minor repairs and that s easier than repairing a big area of overworked finish. Hardwood floors add a warm and natural glow to any room. I tried touching it up by rolling on some poly but the finish is matte and somewhat cloudy from.

I have had repairs done on oak floors that resulted in refinishing small areas. Missed a spot applying poly. Sand the area clean it with a solvent afterwards denatured alcohol apply polyurethane let dry. Spot refinishing hardwood floors.